Introduction
ENC28J60 Ethernet Module is based on Microchip’s ENC28J60 stand-alone 10Base-T Ethernet controller. The ENC28J60 is a stand-alone Ethernet controller with an industry standard Serial Peripheral Interface (SPI). It is designed to serve as an Ethernet network interface for any controller equipped with SPI. The ENC28J60 meets all of the IEEE 802.3 specifications. It also provides an internal DMA module for fast data throughput and hardware assisted checksum calculation, which is used in various network protocols. Communication with the host controller is implemented via an interrupt pin, if required, and the SPI, with clock rates of up to 20 MHz. It has dedicated pins for LED link and network activity indication. The module includes RJ45 Ethernet connector with built-in magnetic and link indicator LEDs. The onboard low drop voltage regulator supplies stable voltage to the Ethernet controller. It is an ideal device for applications involving Home/Office Automation, Remote Diagnostics systems, Industrial equipments, Security Systems and Robotics as well.
Specifications
- Operating Supply: 5V-9V DC
- On board 3.3V low drop voltage regulator for Ethernet controller
- On board RJ45 Ethernet 10/100B Magjack Connector with Indicator LEDs
- Requires Host microcontroller with integrated SPI
- Direct Host to module connection via 9 pin berg strip connector (lengthy wires are not recommended for SPI interface)
- Board Dimension: : 53(L) X 35(W) mm
- Two layer PTH PCB for giving extra strength to the connectors
ENC28J60 Features
- Supply: 3.3V, 5V Tolerant Inputs
- IEEE 802.3. Compatible Ethernet Controller
- Fully Compatible with 10/100/1000Base-T Networks
- Integrated MAC and 10Base-T PHY
- Supports One 10Base-T Port with Automatic
- Polarity Detection and Correction
- Supports Full and Half-Duplex modes
- Programmable Automatic Retransmit on Collision
- Programmable Padding and CRC Generation
- Programmable Automatic Rejection of Erroneous Packets
- SPI Interface with Clock Speeds Up to 20 MHz
- 8-Kbyte Transmit/Receive Packet Dual Port SRAM
- Internal DMA for Fast Data Movement
- Supports Unicast, Multicast and Broadcast Packets
- Supports Unicast, Multicast and Broadcast Packets
- Six Interrupt Sources and One Interrupt Output Pin
- 25 MHz Clock Input Requirement
- Clock Out Pin with Programmable Prescaler
- Operating Voltage of 3.1V to 3.6V (3.3V typical)
Applications
- Home/Office Automation
- Remote Diagnostics Systems
- Industrial Automation
- Security Systems
- Industrial Equipments
- Data Acquisition Systems
- Robotics
Application Example
Note:
For interfacing ENC28J60 based Ethernet module with the host microcontroller requires fair amount of expertise. Microchip has developed a free, configurable TCP/IP stack for its own microcontroller portfolio. It also has a lot of application notes related to stack which can be accessed through Microchip website. For any further information on using the Microchip stack please contact microchip technical support. All the Ethernet modules are carefully tested for the performance. Nex Robotics will not be able to extend its support beyond sales and any kind of product defect.
Downloads
ENC28J60 Manual
ENC28J60 Datasheet
AN833 - Microchip TCP/IP Stack Application Note
Microchip TCP/Ip Stack v5.31
Visit forum for Online Discussion on this product
|
Print
