Quadrotor Mega DIY kit without flight controller

Introduction

This is a combination of matched Quad Frame, BLDC motors, ESCs, Propellers and other required accessories to help you quickly build your own Quadrotor platform.

Quadrotor 49.5cm Diameter Frame is a sturdy yet light weight frame which is capable of surviving repeated crashes. It comes with dedicated power distribution board for connecting LiPo battery with all ESCs. Each BLDC motor with its matched Propeller Matched Pair is capable of providing maximum thrust of 900gms.

This quad rotor gives maximum thrust of 3.6Kgs while it weights around 1.2Kgs. The ESC included in the package is factory programmed and ready to use.

Combo pack contains a FS-CT6B 6ch 2.4GHz transmitter & receiver which can give range up to 1Km in RF line of sight. It also has high performance Lithium Polymer 3 Cell, 11.1V, 5000mAh, 20C discharge Battery with Protection Circuit for 3 Cell Li-Po Battery combined with B6AC Universal Battery Charger.

Note: Kit comes in unassembled form

Kit contains:

Quadrotor 49.5cm Diameter Frame: Qty 1
Brushless DC Outrunner Motor: Qty 4
20Amp BLDC ESC: Qty 4
Pusher and Puller Propeller Matched Pair: Qty: 2 Pair
FS-CT6B 6ch 2.4GHz transmitter & receiver: Qty 1
Lithium Polymer 3 Cell, 11.1V, 5000mAh, 20C discharge Battery: Qty 1
Protection Circuit for 3 Cell Li-Po Battery: Qty 1

Required:

Quadrotor controller
B6AC Universal Battery Charger: Qty 1

Warning: Flying multirotor platforms requires considerable amount of practice and skill. If not handled correctly, it can cause severe injury. Please read the flight controller manual carefully before starting. Please make sure that you remove the props before doing any caliberation and/or configuration changes.

Visit forum for Online Discussion on this product

Customer Reviews: