Quadrotor Combo Pack (Full) with HobbyKing KK2.1.5 Multi-rotor LCD Flight Control Board With 6050MPU

Introduction

This is a "guaranteed to fly" combination of well known and time tested HobbyKing KK2.1.5 Multi-rotor LCD Flight Control Board With 6050MPU And Atmel 644PA with matched Quad Frame, BLDC motors, ESCs, Propellers and other required accessories to help you quickly build your own Quadrotor platform. What's more? This configuration is proven to fly. See the video below to believe it.

The muti-rotor controller board is HobbyKing KK2.1.5 Multi-rotor LCD Flight Control Board With 6050MPU And Atmel 644PA with following specifications,
Size: 50.5mm x 50.5mm x 12mm
Weight: 21 gram
IC: Atmega644 PA
Gyro: 6050MPU InvenSense Inc.
Auto-level: Yes
Input Voltage: 4.8-6.0V
AVR interface: standard 6 pin.
Signal from Receiver: 1520us (5 channels)
Signal to ESC: 1520us

Quadrotor 49.5cm Diameter Frame is a sturdy yet light weight frame which is capable of surviving repeated crashes. It comes with dedicated power distribution board for connecting LiPo battery with all ESCs. Each BLDC motor with its Pusher and Puller Propeller Matched Pair is capable of providing maximum thrust of 880gms.

This quad rotor is capable of providing maximum thrust of 3.5Kgs. The approximate weight is around 1.2Kgs. The included ESC is factory programmed and ready to use.

Combo pack contains a FS-CT6B 6ch 2.4GHz transmitter & receiver which can give range up to 1 km of RF line of sight. It also includes a high performance Lithium Polymer 3 Cell, 11.1V, 5000mAh, 20C discharge Battery with Protection Circuit for 3 Cell Li-Po Battery.

Note: Kit comes in unassembled form. The contents are tested to work together to have a fully functional flying platform. Occational tuning of flight controller may be required.

Kit contains:

Hobbyking KK2.1.5 Multi-rotor LCD Flight Control Board With 6050MPU And Atmel 644PA: Qty 1
Quadrotor 49.5cm Diameter Frame: Qty 1
Power track Top and Bottom PCB: Qty 1 each 
Brushless DC Outrunner Motor: Qty 4
BLDC ESC: Qty 4
Pusher and Puller Propeller Matched Pair: Qty: 2 Pair
6 Channel 2.4GHz Remote Control with Receiver: Qty 1
Lithium Polymer 3 Cell, 11.1V, 5000mAh, 20C discharge Battery: Qty 1
Protection Circuit for 3 Cell Li-Po Battery: Qty 1
LiPo Battery charger

Warning: Flying multirotor platforms requires considerable amount of practice and skill. If not handled correctly, it can cause severe injury. Please read the flight controller manual carefully before starting. Please make sure that you remove the props before doing any caliberation and/or configuration changes.

Visit forum for Online Discussion on this product

Customer Reviews: