Print Print
Print
200 RPM Side Shaft Heavy Duty DC Gear MotorLithum Polymer 4 cell, 14.8V 2000mAh discharge Battery

Ultrasonic Range Finder I2CXLEZ0-MB1202
View Full-Size Image


Ultrasonic Range Finder I2CXLEZ0-MB1202

Product ID: NR-S-UL-I2CEZ-MB1202
Weight: 6 gms
Price: Rs.2,804.89

Ask a question about this product

  
In Stock: 50
Usually ships in:

5week.gif

Introduction

The I2CXL-MaxSonar-EZ series is the first MaxSonar ultrasonic sensor to feature the I2C interface. The sensor have high acoustic power output along with real-time auto calibration for changing conditions (voltage and acoustic or electrical noise) that ensure users receive the most reliable (in air) ranging data for every reading taken.

The I2CXLEZ0-MB1202 offers the widest and most sensitive beam pattern of the I2CXL-MaxSonar-EZ sensors that are offered. This makes the I2CXLEZ0-MB1202 an excellent choice wherever wide beam detection, reliable people detection, or reliable small obstacle detection are required.

This sensor provides very short to long-range detection and ranging, in a tiny and compact form factor. It detect objects from 0-cm to 765-cm (25.1 feet) and provide sonar range information from 20-cm out to 765-cm with 1-cm resolution. Objects from 0-cm to 20-cm typically range as 20-cm.

Note: Object from 0-mm to 1-mm may not be detected.

Specifications/Features

  • Resolution: 1-cm
  • Data refresh rate: up to 40Hz
  • Range: 20cm to 765cm (25 Feet)
  • Sensor operates at 42kHz
  • Virtually no sensor dead zone, objects closer than 20 cm will typically range as 20 cm
  • Operating voltage: 3V-5.5V
  • Average current requirement: 4.4mA
  • Operational Temperature from 0°C to +65°C (32°F to +149°F)
  • I2C bus communication allows rapid control of multiple sensors with only two wires
  • Easy control of multiple sensors
  • Control up to 127 sensors using two wires
  • Firmware filtering for better noise tolerance and clutter rejection
  • Widest beam pattern in I2CXL-MaxSonar-EZ sensor family
  • Status pin available to determine sensor state also Power-up address reset pin is available

Multiple Sensor Reference Wiring Diagram
Adding additional sensors to the I2C bus is extremely simple, as long as each sensor is programmed first to a different address, and the bus capacitance is low enough for the pull-up resistors to work properly. GND, V+, SCL and SDA simply need to be connected to the existing wires that the bus operates on. Each sensor can then be addressed individually to perform a range finding cycle or return the range data.
Note: For more detail refer datasheet.

Ultrasonic Range Finder EZ0 Dimension

Dimensions

Ultrasonic Range Finder EZ0 Dimension

Documents

I2CXL-EZ0 sensor datasheet
I2CXL-EZ0 sensor Beam width explanation
Maxbotics FAQ

Visit forum for Online Discussion on this product



ROHS Compliant : YES


Customer Reviews:

There are yet no reviews for this product.
Please log in to write a review.