ACS709 75Amp Hall Effect Current Sensor Module

Introduction

ACS709-75A  current sensor IC provides economical and precise means for current sensing applications in industrial, automotive, commercial, and communications systems. It also gives user settable over current fault output for overload detection.

The ACS709-75A consists of a precision linear Hall sensor integrated circuit with a copper conduction path located near the surface of the silicon die. Applied current flows through the copper conduction path, and the analog output voltage from the Hall sensor IC linearly tracks the magnetic field generated by the applied current. The accuracy of the ACS709-75A is maximized because the Hall element is situated in extremely close proximity to the current to be measured. High level immunity to current conductor dV/dt and stray electric fields guarantees low output ripple and low offset drift in high-side applications.

The voltage on the overcurrent Input (VOC pin) allows to define an overcurrent fault threshold for the device. When the current flowing through the copper conduction path (between the IP+ and IP– pins) exceeds this threshold, the open drain Overcurrent Fault pin will transition to a logic low state. Factory programming of the linear Hall sensor IC inside of the ACS709-75A results in exceptional accuracy in both analog and digital output signals.

The internal resistance of the copper path used for current sensing is typically 1.1 mΩ, for low power loss. Also, the current conduction path is electrically isolated from the low voltage device inputs and outputs. This allows the ACS709-75A to be used in applications requiring electrical isolation, without the use of opto-isolators or other costly isolation techniques.

Specification

• Single 5V supply operation.
• Optimized Input range (IP) : +/- 75Amp
• Use-settable overcurrent fault level with less than 2microsecond response time
• Sensitivity : 28mV/Amp at Vcc = 5V
• Low noise analog signal path,
• Stable output offset voltage
• Bandwidth is set via a filter capacitor
• 1.1mOhm internal copper conductor resistance
• 2.1kVRMS minimum isolation voltage
• Ratiometric output from supply voltage

Download
ACS709 75A Current Sensor Module
ACS709 datasheet

Visit forum for Online Discussion on this product

Customer Reviews: